Installing Components

TESTING THE STOP LAMP

Fig 1: Connecting Stop Lamp

Courtesy of VOLVO CARS CORPORATION

Connect a new stop lamp.

Check its function.

Disconnect it.

REMOVING THE BACKING

Fig 2: Double Sided Adhesive Backing

Courtesy of VOLVO CARS CORPORATION

Remove the backing (1) from the double-sided adhesive tape on the stop lamp.

INSTALLING THE STOP LAMP

Fig 3: Identifying Stop Lamp Positioned On Headlining With Bevel

Courtesy of VOLVO CARS CORPORATION

Position the stop lamp on the headlining with the bevel (1)against the headlining.Do not allow the double-sided adhesive tape touch the headlining.

NOTE:

To avoid squeaking it is important that the stop lamp is correctly positioned on the headlining.

Press the stop lamp into place on the headlining.

FINISHING WORK

Fig 4: Identifying Stop Lamp Components

Courtesy of VOLVO CARS CORPORATION

Connect the connector (1) to the stop lamp.

Tape (2) stop lamp wiring to the headlining so that they cannot make a noise.

Install foam rubber (3), just behind the hole for the rear interior lighting. Use contact adhesive, P/N 1161434, if there is too little adhesive left on the foam rubber for it to stick to the headlining.

Install clip (4) in the headlining by pressing straight up and twisting a quarter turn.

Install the interior lighting (5) by pressing straight up.