Reading Off And Programming Data
With this option it is possible to read programmed data and to program in data.
If possible, all data must be read out from the control module before replacement. After replacement the relevant data must be programmed into the new control module. The following customer parameters must be read off before the control module is replaced. This is so that the same information can be programmed in the new control module.
With auto mode:
The general lighting lights and remains lit for 30 seconds when:
The door has been unlocked from outside using a key or remote control.
The engine has been stopped and the ignition key turned to position 0.
The default period is 30 seconds. This can be changed to between 5 seconds and 255 seconds.
The general lighting lights and remains lit for under 10 minutes when:
One of the doors is opened after unlocking.
When the lamp is lit using a button.
The default period can be reprogrammed from 0 to 255 minutes at 10 minute intervals.
The strength of the interior rear view mirror anti-dazzle. There are three positions; a normal position, one with stronger anti-dazzle and one with weaker anti-dazzle.