Pre Delivery Service Checklist 2012
| Model: | Chassis Number: | Mileage before PDS: | Mileage after PDS: |
| New items | |
| Group: | New or changed items: |
| 4. Functional Checks | Items in row 21 and 22 CHANGED: New instructions for checking the alarm. |
1. BEFORE STARTING THE PDS
| Change from Transport Mode to Normal Mode, use VIDA | |||
| Only for C30 D5204TX, C70 D5204TX, S40 D5204TX, V50 D5204TX, S60, S80, S80L, V60, V70, XC60, XC70 and XC90 6 cyl: In Transport mode maximum speed is 30 km/h. | |||
| Review Transporter Delivery Checklist | |||
| Ensure suitable vehicle protection is fitted | |||
| Check QW90 for any outstanding QBs | |||
| Check battery, fill in voltage and code in comments box (Voltage below 12.5V is not OK) (Take measurements directly on battery using a 3100/3200/3300 battery tester) |
2. PRODUCT
| Connect battery charger (4A for a 40Ah battery - 8 A for a 80Ah battery) |
|||
| Vehicles older than 3 months after factory complete, do a PDS upgrade CAN and MOST. XC90, 30745955, 30745956 |
|||
| Read out fault codes and take away root cause/reset according to instruction | |||
| All accessories/enclosed details (in e. g. glove compartment, cargo compartment) installed and functioning correctly. Attach the instruction for leather upholstery on the passenger seat's jacket holder with the Volvo logo visible. |
|||
| Final assembly of ATSVR (After Theft for Stolen Vehicle Recovery) Only XC90 with option code 858. |
|||
| Reset service reminder, VIDA (Volvo Scan Tool): 3 - Maintenance, Service Programs, 38 - Instrumentation, Resetting the SRI to zero |
|||
| Check SRI parameters and ensure that the applicable Service Program for the specific Market, Variant and model year is correctly programmed in the combi-instrument. | |||
3. UNDER BONNET OPERATIONS
| Check engine oil level | |||
| Check coolant level | |||
| Check brake fluid level | |||
| Add windscreen washer fluid to strength | |||
| Check power steering fluid level | |||
| Visually check for oil, water and fuel leaks |
4. FUNCTIONAL CHECKS
| Functional Checks | |||
|---|---|---|---|
| Indicator and warning lights: Check if all lights illuminate and turn off, while engine is started. Check DIM concerning WARNING INFO Special attention to STC/DSTC light |
|||
| S80 Executive: with option code 998351 (refrigerator). The crystal glass and bottle opener is placed behind left panel in luggage compartment. | |||
| Set time clock | |||
| - Optional Volvo on Call function should be installed and adjusted according to VIDA: "Activating the Volvo on Call" | |||
| Check function of RTI, including control functions on steering wheel | |||
| Check function of infotainment | |||
| Check horn at all corners of horn pad | |||
| Check function of all front and rear external lights | |||
| Check mid-console functions | |||
| Check function of washer jets (front and rear windscreen) | |||
| Check function of wipers | |||
| Check functions of power windows, all switches, auto up and down functions and cut off on rear | |||
| Check all seat adjustment functions (motor seat including memory) | |||
| Check all seatbelts for correct operation | |||
| Check boot and fuel lid opening switches if applicable | |||
| Check back door child safety lock operation | |||
| Check central locking and alarm | |||
| - Check central lock function of doors and tailgate/boot | |||
| - Check central lock function with both remote control devices | |||
| - Check the function of alarm in the following way: With all doors, trunk and hood closed, lock the car with the remote key (Lock button). Leave the car locked for at least 30 seconds. Unlock the car and switch to ignition mode 2 (Ignition on). No messages regarding the alarm should be displayed on the information displays. | |||
| - Check all keys in all locks | |||
| - Check Keyless car operation | |||
| - Open and close all doors, check for cracking, noisy doorstops, smooth operation of hinges and handle | |||
5. ON LIFT OPERATIONS
| Inspect for visual oil, water and fuel leaks | |||
| Check condition and security of: | |||
| - Exhaust | |||
| - Heat Shield | |||
| - Catalytic Converter | |||
| - Check for gearbox leaks. Remove plastic engine/gearbox cover where appropriate |
|||
| - Check for underbody damage | |||
| Check air/water and fuel connections for security and routing | |||
| Set tire pressure to the correct value (see label) | |||
| Where appropriate, ensure locking wheel nuts are fitted, place locking wheel nut registration form from package into New Car Preparation Process folder | |||
| Remove the brake disc protection only if car is not going to stock (if equipped) | |||
| Remove spring extenders (if equipped) | |||
| Check tires and rims for damage and correct tire size | |||
| Check lower part of car for damage. Special attention to be given to bumpers, spoilers and lower side of doors |
6. TEST-DRIVE TO BE AT LEAST FIVE MILES (8.5 KM) OVER VARIED DRIVING CONDITIONS
| BEFORE STARTING THE ENGINE | |||
| Ignition and steering lock function | |||
| Automatic gearbox: starter motor only functions in position P and N, reversing lamp in position R | |||
| WHEN STARTING - CHECK | |||
| - Brake pedal travel | |||
| - Starter motor function | |||
| - Engine starts normally | |||
| - Idle speed | |||
| WHEN MOVING OFF - CHECK | |||
| - Parking brake operation, efficiency and lever travel | |||
| - Clutch snatch/slip | |||
| - Acceleration is normal, no pinking, unusual noise | |||
| WHEN MOVING OFF - CHECK, CONT. - Gearbox function, select all gears |
|||
| - Steering: play, abnormal stiffness or noise | |||
| - Pulling to one side/unstable feeling | |||
| - Steering wheel correctly aligned | |||
| DURING DRIVING - CHECK | |||
| - All heating/air conditioning functions and two- or three-stage heated seats, operate all fittings | |||
| - Trip computer function | |||
| - Speedometer function | |||
| - Tachometer function | |||
| - Information center function (all settings) | |||
| - Fuel gauge functions and temperature gauge | |||
| - Cruise control operation | |||
| Check audio system: | |||
| - Check function of controls: balance, tone fader, tuning, band selector | |||
| - Check for noises and interference on all bands and CD player | |||
| - Check autostore and set radio channels for FM, AM, DAB (option) (contact Sales for preferred stations) | |||
| - Check Dolby Surround Pro Logic | |||
| - Reset the compass function according to VIDA (Volvo Scan Tool): "Reset Compass Function" | |||
| WHEN BRAKING | |||
| Bed in parking brake pads/shoes | |||
| AFTER TEST-DRIVE | |||
| Check and adjust alignment of headlamps and auxiliary lamps |
7. ENDING PDS
| Fill in actual PDS finish date here: | |||
| Check battery, fill in voltage and code in comments box. (Voltage below 12.5 V is not OK). (Take measurements directly on battery using a 3100/3200/3300battery tester) |
|||
| Read out Diagnostic trouble codes (DTC). Remedy any permanent DTC/reset according to VIDA (Volvo Scan Tool) instruction.
NOTE:
Do not automatically update to newer software unless the Diagnostic instruction requires it. |
|||
8. VALET - CHECKING INTERIOR AND EXTERIOR
| Remove rapguard - see TIE, TJ - 29 | |||
| Wash the car | |||
| Check for marks on bumpers | |||
| Inspect the surface finish for any dents, scratches, defects or paint damage | |||
| - Special attention to paint chips on door edges | |||
| Inspect items for cleanliness and damage | |||
| - Special attention to seats | |||
| Check carpets especially in rear cargo area | |||
| Clean windows inside and outside, check for scratches | |||
| Fit immobiliser/alarm/radio stickers | |||
| Wipe steering wheel, gear lever and handbrake clean | |||
| Check if internal leakage inside car after car wash | |||
| Remove plastic transport protection inside car | |||
| Appropriate manuals and/or booklets are in place | |||
| Place the Quick Guide on the passenger seat |