Front Fender: Service and Repair

FRONT FENDER PANEL REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.

2. Remove the following parts:
a. Sail garnish (See Service and Repair)

b. Side turn lights (See Side Turn Light Removal/Installation)

c. Front bumper (See Front Bumper Removal/Installation)

d. Front combination lights (See Service and Repair)

e. Side step molding (vehicles with side step molding) (See ) (See )

3. Remove fastener A, then remove the front fender molding in the direction of the arrow shown in the figure.






4. Remove bolt B and clip C, then remove the front bumper slider.






5. Remove bolts D, then remove the front fender panel in the direction of the arrow shown in the figure.






6. Install in the reverse order of removal.

7. Adjust the headlight aiming. (See Adjustments)