Engine Will Not Run
- Remove injector connector and measure resistance between 2 terminals of injector. Resistance should be 1.5-2.5 ohms. If resistance is not within specifications, replace injector. If resistance is as specified, check fuel pressure.
- If fuel pressure is as specified, check whether there is any short-circuiting, wire breakage or poor connections in wire between main relay and resistor. Check whether resistor is open or corroded. Check whether there is any short-circuiting, wire breakage, or poor connections in the wire between resistor and injector. Check whether there is any short-circuiting, wire breakage or poor connections in wire between injector and ECU. If all is okay, check the ECU.