Abs Modulator Unit: Installation
WARNING: This page is about a different car, the 1997 Acura 3.5RL. However, it is still accessible from the selected car via links, so may be relevant.
Ensure brake fluid level in reservoir is to MAX level. Slowly tilt ABS modulator unit suction port upward, about 45-degrees, to bleed air from suction port. To complete installation, reverse removal procedure. Bleed brake system. See BLEEDING BRAKE SYSTEM. Start engine and allow to idle a few minutes. Ensure ABS indicator light goes out and there are no brake fluid leaks. Stop engine and ensure brake fluid level in reservoir is filled to MAX level.