Passenger's Power Window Switch Test
Remove passenger's power window switch and armrest pocket from door panel. Disconnect 5-pin connector (8-pin connector on 3.5RL) from switch. Check for continuity between specified switch terminals with switch in each specified position. See PASSENGER'S POWER WINDOW SWITCH TEST table. If continuity is not as specified, replace passenger's power window switch. See Figure or Figure .
PASSENGER'S POWER WINDOW SWITCH TEST
| Window Switch Position | Continuity Between Terminals | ||
|---|---|---|---|
| 2.5TL & 3.2TL | |||
| Front, Right Rear & Left Rear | |||
| UP | 1 & 4; 2 & 3 | ||
| OFF | 2 & 3; 4 & 5 | ||
| DOWN | 1 & 3; 4 & 5 | ||
| 3.5RL | |||
| Front, Right Rear & Left Rear | |||
| UP | 2 & 3; 1, 5, 7 & 8 | ||
| OFF | 1, 2, 3, 5, 7 & 8 | ||
| DOWN | 1 & 3; 2, 5, 7 & 8 | ||