October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Ignition Control Module (ICM) Input Test (CR-V)
- Turn ignition off. Remove distributor cap, rotor and leak cover. Disconnect wires from ICM. See Figure. Turn ignition on. Check for voltage between ground and Black/Yellow wire. If battery voltage exists, go to next step. If battery voltage does not exist, check for an open in Black/Yellow wire between ignition switch and ICM. See
WIRING DIAGRAMS article. Repair wire as necessary.
- Turn ignition on. Check for voltage between ground and White/Blue wire. If battery voltage exists, go to next step. If battery voltage does not exist, check ignition coil. See appropriate IGNITION COIL RESISTANCE TEST . Replace coil as necessary. If ignition coil is okay, check for an open in White/Blue wire between ICM and ignition coil. See
WIRING DIAGRAMS article.
- Disconnect PCM 25-pin connector "B". Check for continuity in Yellow/Green wire between ICM and PCM 25-pin harness connector "B" terminal No. 13. If continuity exists, go to next step. If continuity does not exist, repair open in Yellow/Green wire.
- Check for continuity between ground and Yellow/Green wire. If continuity exists, repair short to ground in Yellow/Green wire. If continuity does not exist and wiring is okay, replace ICM.