LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2000 >> 3.2TL >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Air Bag Restraint Systems) >> Diagnostics >> Erasing Diagnostic Trouble Code Memory >> Erasing DTC Memory Using SCS Service Connector
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Erasing DTC Memory Using SCS Service Connector

WARNING: This page is about a different car, the 2002 Acura 3.5RL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition off. Connect SCS Short Connector (07PAZ-0010100) to Memory Erase Signal (MES) connector. See Fig 1.
  2. Turn ignition on. SRS indicator light will come on for about 6 seconds then go off.
  3. Disconnect SCS short connector from MES connector within 4 seconds after SRS indicator light goes off. SRS indicator light will come on again.
  4. Reconnect SCS short connector to MES connector within 4 seconds after SRS indicator light comes on. SRS indicator light will go off.
  5. Disconnect SCS short connector from MES connector within 4 seconds. SRS indicator light will indicate that memory is erased by blinking 2 times.
  6. Turn ignition off, and wait 10 seconds before proceeding with troubleshooting.
Fig 1: Locating Memory Erase Signal (MES) Connector
G99H00163Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals