System Check
WARNING: This page is about a different car, the 2009 Acura MDX, 2008 Acura MDX, and 2007 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the HDS to the data link connector.
- Turn the ignition switch ON (II).
- Monitor the System Check in the Immobilizer Info with the HDS.
- If the HDS displays the "Immobilizer system is normal", the immobilizer system is OK. If the HDS displays any other messages, check as follows:SYSTEM CHECK CHART
Status Log No. System Check Possible Failures A-1 Immobilizer system is not normal - This key is not registered in the immobilizer-keyless control unit. Try to register keys by using "KEYS".
- The communication was not good between the antenna and the immobilizer key by influence of metal such as key chains.
- The communication was not good between the antenna and the immobilizer key by battery voltage low.
A-2 Immobilizer system is not normal - Intermittent interruption between transponder and immobilizer-keyless control unit.
- The immobilizer key type is different. It is not for this vehicle but for another one or for other company's one.
- Key failure (transponder failure)
- The communication was not good between the antenna and the immobilizer key by influence of metal such as key chains.
- The communication was not good between the antenna and the immobilizer key by battery voltage low.
A-3 Immobilizer system is not normal - The ignition switch was turned ON (II) with a non-immobilizer key.
- The immobilizer key type is different. It is not for this vehicle but for another one or for other company's one.
- Key failure (transponder failure)
- The communication was not good between the antenna and the immobilizer key by influence of metal such as key chains.
- The communication was not good between the antenna and the immobilizer key by battery voltage low.
- Immobilizer-keyless control unit failure
B-1 Immobilizer system is not normal - The PCM was not registered. Try to register the PCM by using "REPLACE PCM".
- The communication was not good between the PCM and the immobilizer-keyless control unit by battery voltage low.
- The communication was not good between the immobilizer-keyless control unit and the PCM by influence of some noise.
B-2 Immobilizer system is not normal - The PCM was not registered. Try to register the PCM by using "REPLACE PCM".
- The communication was not good between the PCM and the immobilizer-keyless control unit by battery voltage low.
- The communication was not good between the immobilizer-keyless control unit and the PCM by influence of some noise.
D-1 Immobilizer system is not normal - Harness short from the PCM to the immobilizer-keyless control unit. (IMOCD/S-NET line short)
- The communication was not good between the PCM and the immobilizer-keyless control unit by battery voltage low.
- The communication was not good between the immobilizer-keyless control unit and the PCM by influence of some noise.
- Immobilizer-keyless control unit failure
- PCM failure
D-2 Immobilizer system is not normal - Blown fuse
- Harness open from the immobilizer control unit-receiver and the imoes unit.
- The communication was not good between the immobilizer control unit-receiver and the imoes unit by influence of some noise.
D-3 Immobilizer system is not normal - Blown fuse
- Harness open from the PCM to the immobilizer-keyless control unit.
- The communication was not good between the PCM and the immobilizer-keyless control unit by battery voltage low.
- The communication was not good between the immobilizer-keyless control unit and the PCM by influence of some noise.
- Immobilizer-keyless control unit failure
- PCM failure