DTC B1705: Display Panel Control Unit Lost Communication with the Gauge Control Module (Engine Temperature Signal)
NOTE:
- Display panel control unit DTCs may not clear using the HDS. If the DTCs will not clear, manually reset the display panel control unit (see GENERAL TROUBLESHOOTING INFORMATION ).
- If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN system diagnosis test mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A ).
- Clear the DTC with the HDS.
- Turn the ignition switch OFF, and then back ON (II).
- Check for DTCs with the HDS.
Are DTCs B1008, B1011, B1060, B1061, B1805, and B1808 indicated?
- YES- Go to the Gauge Control Module Input Test (see GAUGE CONTROL MODULE INPUT TEST ).
- NO- Replace the display panel control unit.