Key Interlock Solenoid Test

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service.

1. Remove the driver's dashboard lower cover and the lower steering column cover.
2. Disconnect the steering lock assembly connector.
3. Insert the ignition key in the key cylinder, then turn the ignition key to ACCESSORY (I).
4. Connect the battery positive terminal to steering lock assembly connector terminal No. 4, and connect the battery negative terminal to No. 3 terminal. Make sure that the ignition key cannot be turned to LOCK (0) position. Disconnect the battery terminals, and make sure that the key can be turned to LOCK (0) position and removed from the cylinder.
   Fig 1: Connecting Battery Terminals To Steering Lock Assembly Connector Terminals

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. If the key interlock solenoid works improperly, replace the ignition key cylinder/steering look assembly (see STEERING LOCK REPLACEMENT ).