DTC B1066: Relay Control Module Lost Communication with Keyless Access Control Unit (PANIC Message)
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see
TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A
).
- Clear the DTCs with the HDS.
- Turn the ignition switch OFF, and then back ON (II).
- Wait for 6 seconds or more.
- Check for DTCs with the HDS.
Is DTC B1066 indicated?
YES - Go to step 5.
NO - Intermittent failure, the communication line is OK at this time.
- Check for DTCs with the HDS.
Is DTC B1016 also indicated?
YES - Do the keyless access control unit input test (see CONTROL UNIT INPUT TEST ).
NO - Do the relay control module input test (see RELAY CONTROL MODULE INPUT TEST ).