Audio-HVAC Display Module Assembly Removal/Installation

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ), and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before performing repairs or service.

NOTE:

Eject all the discs before removing the audio unit to prevent damaging the CD/DVD player's load mechanism.
Put on gloves to protect your hands.
Take care not to scratch the dashboard and related parts.
Lay a workshop towel under the parts when working on them to protect the face panel from scratches or other damage.

Make sure you have the anti-theft codes for the audio system.
Remove the center console trim (see CENTER CONSOLE REAR SECTION REMOVAL/INSTALLATION ) and center console panel (see CENTER CONSOLE PANEL REMOVAL/INSTALLATION ).
Remove the dashboard center vent (see DRIVER'S DASHBOARD UNDERCOVER REMOVAL/INSTALLATION ).
Remove the bolts, then pull out the audio-HVAC display module assembly (A).

Fig 1: Identifying Audio-HVAC Display Module Assembly
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the connectors (B, C), then remove the audio-HVAC display module assembly.
Install the audio-HVAC display module assembly in the reverse order of removal, and note these items:
- Make sure all connectors and AM/FM antenna sublead are secure.
- Enter the anti-theft codes for the audio system.