DTC U1289: Gauge Control Module Lost Communication with Remote Slot Control Unit
WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see
TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A
)
- Clear the DTCs with the HDS
- Press the engine start/stop button to select the OFF, ACC, ON, and OFF mode
- Wait for at least 6 seconds
- Check for DTCs with the HDS
Is DTC U1289 indicated?
YES -Go to the remote slot control unit input test, and do all power, ground, and communication input tests (see REMOTE SLOT CONTROL UNIT ) If the tests prove OK, replace the remote slot control unit (see REMOTE SLOT CONTROL UNIT )
NO -Intermittent failure, the system is OK at this time Check for loose or poor connections at the remote slot control unit 40P connector and the related units