ABS Modulator-Control Unit Removal and Installation: Installation
- Install the ABS modulator-control unit on the brackets.
- Install the bracket with the ABS modulator-control unit to the body.
- Reconnect the six brake lines, then tighten the flare nuts to the specified torque.
- Align the connecting surface of the ABS modulator-control unit 25P connector to the ABS modulator-control unit.
- Lower the lock of the ABS modulator-control unit 25P connector, then confirm the connector is fully seated.
- Bleed the brake system (see BRAKE SYSTEM BLEEDING ).
- Start the engine, and check that the ABS indicator goes off.
- Test-drive the vehicle, and check that the ABS indicator does not come on.
NOTE:
If the brake pedal is spongy, there maybe air trapped in the modulator and then induced into the normal brake system during modulation. Bleed the brake system again (see
BRAKE SYSTEM BLEEDING
).