Forced Starting of Display: Notes

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

SCS service connector 07PAZ-0010100

Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode
Remove the right side kick panel (see TRIM REMOVAL/INSTALLATION - DOOR AREAS )
Connect the SCS service connector (A) to the navigation service connector (B) located by the passenger's kick panel

Fig 1: Connecting SCS Service Connector To Navigation Service Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode
Check that the diagnosis menu for the picture diagnosis starts up, and then changes to the system link menu
NOTE: If the display fails to display the system link screen, refer to no picture is displayed (see No picture is displayed )