Navigation Display Unit Removal/Installation

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Put on gloves to protect your hands
Take care not to scratch the dashboard and related parts
Lay a shop towel under the parts when working on them to protect the face panel from scratches or other damage
When prying components, use the handy remover set or equivalent

Remove the dashboard center vent (see DASHBOARD CENTER VENT REMOVAL/INSTALLATION )
Remove the screws and bolt from the navigation display unit (A)

Fig 1: Identifying Navigation Display Unit
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Bolt specifications: 5 x 0.8 mm, 4.4 N.m (0.45 kgf m, 3.2 lbf ft)
Pull out the navigation display unit Then disconnect the connector (A) from the navigation display unit

Fig 2: Disconnecting Connector From Navigation Display Unit
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the navigation display unit in the reverse order of removal