LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2009 >> CSX Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Navigation System) >> System Description >> Interface Dial Inputs and Outputs
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Interface Dial Inputs and Outputs

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Interface Dial 5P Connector
G05989712Courtesy of AMERICAN HONDA MOTOR CO., INC.
INTERFACE DIAL 5P CONNECTOR TERMINAL REFERENCE

Terminal Number Wire Color Terminal Name Description Voltage (about) Symptom
1 BLU JOG (jog) Interface dial operation signal 0-5 V pulses If open You can not operate the navigation system If short to ground You can not operate the navigation system
2 GRY(1) JOG SH (Shield jog) Shield for interface dial signal -- --
3 BLK GND (Ground) Ground for interface dial 0V If open You can not operate the navigation system
If short to ground You can not operate the navigation system
4 PUR ACC (Accessory) Power source for interface dial Battery voltage at ACC mode If open You can not operate the navigation system
If short to ground Blows fuse No 18 (7 5 A) in the driver's under-dash fuse/relay box
(1) The shielded wires have a heat-shrink tube insulating the outside of the wire

The color of the insulating tube, typically black or dark gray, may not match the color of the wire shown on the circuit diagram