Rear Power Window Switch Test

Rear Power Window Switch Test

1. Remove the rear door panel, Rear Door Panel Removal/Installation and disconnect the 14P connector from the switch.

2. Test the rear power window switch:
- When the power is connected to terminal No. 2 and ground is connected to terminal No. 14. There should be continuity between terminals No. 8 and No. 1.

- When the power is connected to terminal No. 6 and ground is connected to terminal No. 14. There should be continuity between terminals No. 8 and No. 7.

- When the power is connected to terminal No. 8 and ground is connected to terminal No. 14, then push the rear power window switch to DOWN. There should be continuity between terminals No. 8 and No. 1.

- When the power is connected to terminal No. 8 and ground is connected to terminal No. 14, then pull the rear power window switch to UP. There should be continuity between terminals No. 8 and No. 7.

3. If the continuity is not as specified, replace the switch.