LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Acura >> 2011 >> MDX >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Navigation System >> System Description >> Navigation Display Unit Inputs and Outputs >> Interface Dial Inputs and Outputs
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Interface Dial Inputs and Outputs

Fig 1: Identifying Interface Dial 5P Connector
G08058079Courtesy of AMERICAN HONDA MOTOR CO., INC.
INTERFACE DIAL 5P CONNECTOR

Terminal Number Wire Color Terminal Name Description Voltage (about) Symptom
1 WHT JOG BUS (Interface dial Jog) Interface dial operation signal 0-5 V pulses If open: You can not operate the navigation system. If short to ground: You can not operate the navigation system.
2 BRN(1) JOG SH (Interface dial Jog shield) Shield for interface dial signal --- ---
3 BLK GND (Ground) (G506) Ground for interface dial 0V If open: You can not operate the navigation system. If short to ground: You can not operate the navigation system.
4 PUR ACC (Accessory) Power source for interface dial Battery voltage at ACCESSORY (I) If open: You can not operate the navigation system. If short to ground: Blows fuse No. 32 (10 A) in the under-dash fuse/relay box.
(1) The shielded wires have a heat-shrink tube insulating the outside of the wire. The color of the insulating tube, typically black or dark gray, may not match the color of the wire listed on the schematic.
scientia non olet · About LEMON Manuals