| The mode changes between ACC and ON, but it is difficult to change to OFF |
- Check the keyless access control unit
- Check the gauge control module
- Check the park pin switch
|
- Gauge control module
- Keyless access control unit
- PCM
- B-CAN communication line open/short
- F-CAN communication line open/short
- Speed signal line open
- Park pin switch
- P-PIN SW line open
|
| Engine start/stop switch does not work |
Check for DTCs. If any DTC is indicated, go to the DTC troubleshooting |
- ACC relay circuit
- Keyless access control unit
- Engine start/stop switch
- SS1 (+) line short
- SS2 (-) line short
- Harness
|
| Engine does not crank (power supply is normal) |
- Check the brake pedal position switch
- Check the keyless access control unit
|
- Keyless access control unit
- STS line open/short
- Brake pedal position switch
- +B STOP line open/short
|
| The engine starts, but stalls immediately |
Symptom troubleshooting |
- No power to PCM
- No power to MICU
- Keyless access control unit
- Gauge control module
- Electric steering lock
- Harness/connections
|
| Keyless access indicator does not go off or does not come on |
Symptom troubleshooting |
- Gauge control module
- Keyless access control unit
- Harness/connections
|
| Immobilizer indicator does not go off or does not come on |
Symptom troubleshooting |
- Gauge control module
- Keyless access control unit
- PCM
- Harness/connections
|
| All the doors and the trunk lid will not lock and unlock |
Symptom troubleshooting |
- Keyless access control unit
- LF antenna
- Driver's door lock knob switch
- Door outer handle touch sensor/lock switch
- Door lock actuators
- Keyless remote
- Low or weak keyless remote battery
- Not registered
|