LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> American Motors >> 1980 >> AMX Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Computerized Emission Control (CEC) System >> Diagnosis >> Initialization Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Initialization Check

  1. While observing metering pins, have helper turn ignition switch to "ON" position. Metering pins should move fully toward front to vehicle, reverse direction and move partially toward rear of vehicle. They should then stop for approximately 40 seconds and then move in either direction.
    NOTE: Metering needles work in tandem. Only 1 needle will be visible in carburetor.
  2. If pins do not move after 40 seconds, check vacuum hose routing or replace CTO and continue diagnostic checks. If pins fail to move at all, perform Initialization Test sequence.
    NOTE: Switch colors referred to in Checks and Tests are color of switches lead wire.
scientia non olet · About LEMON Manuals