Basic Setting

WARNING: This page is about a different car, the 1993 Audi 90 and 1993 Audi 100. However, it is still accessible from the selected car via links, so may be relevant.

Lock camshafts at TDC No. 3 cylinder with Timing Fixture (V.A.G. 3243). Locating plates are used to position camshafts. Each locating plate has a large hole and a small hole. When installing timing fixture, ensure the large holes on locating plates face each other. See Fig 1 .
Lock crankshaft at TDC No. 3 cylinder with Crank Locating Pin (V.A.G. 3242) inserted through threaded hole in block where reference sensor usually is, and into locating notch in crankshaft. See Fig 2 . Fit and tension cam drive belt. Remove timing fixture and locating pin.

Fig 1: Timing Camshafts

Courtesy of AUDI OF AMERICA, INC.

Fig 2: Timing Crankshaft

Courtesy of AUDI OF AMERICA, INC.