LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 1997 >> A6 Avant, 2.8 A >> Repair and Diagnosis >> Quick Lookups >> DTC Index >> Automatic Transmission DTCS
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Automatic Transmission DTCS

AUTOMATIC TRANSMISSION DTCS

SAE Code VAG Code Code Description
N/A 01236 Shift Lock Solenoid
N/A 00668 Terminal No. 30 (Battery Voltage Fault)
N/A 00526 Brake Light Switch
N/A 00000 No Communication
P0121 00518 TPS Out Of Range
P0560 00548 No Supply Battery Voltage
P0603 65535 Replace TCM (3)
P0605 65535 Replace TCM (3)
P0705 00293 Transmission Range (TR) Switch
P0712 00300 Transmission Temperature Sensor
P0713 00300 Transmission Temperature Sensor
P0721 00297 Transmission Vehicle Speed Sensor
P0726 00543 RPM Upper Limit Exceeded
P0727 00529 RPM Information Missing
P0731 00652 Transmission Range Controller (1)
P0732 00652 Transmission Range Controller (1)
P0733 00652 Transmission Range Controller (1)
P0734 00652 Transmission Range Controller (1)
P0748 00264 Solenoid Valve No. 4
P0753 00258 Solenoid Valve No. 1
P0758 00260 Solenoid Valve No. 2
P0763 00262 Solenoid Valve No. 3
P1704 00296 Kickdown Switch
P1711 00283 Left Front ABS Wheel Speed Sensor
P1716 00285 Right Front ABS Wheel Speed Sensor
P1721 00287 Right Rear ABS Wheel Speed Sensor
P1726 00290 Left Rear ABS Wheel Speed Sensor
P1728 00753 Wheel Speed Sensor Electrical Connector
P1728 00597 Varying Wheel Speed Impulse
P1746 00532 Supply Battery Voltage Low
P1749 01044 Control Module Incorrectly Coded (2)
P1750 00532 Supply Battery Voltage Low
P1766 00638 Engine/Transmission Electrical Connection
P1767 00638 Engine/Transmission Electrical Connection
P1771 00549 Consumption Signal
P1772 00549 Consumption Signal
P1781 00545 Engine/Transmission Electrical Connection
P1782 00545 Engine/Transmission Electrical Connection
(1) Relationship of engine speed to transmission output speed (wheel speed) does not match with drive mode engaged.
(2) Control module identification must be checked. VAG tester must be used to check module coding and to perform module coding procedure.
(3) If all possible faults have been determined and repaired and DTC 65535 is still recorded, replace TCM.