LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 1998 >> A8 Base >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> On Board Diagnostic (OBD) - HVAC, Can & Defrosters >> Automatic Climate Control System, On Board Diagnostic (OBD) >> Read Measuring Value Block (function 08) >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Read Measuring Value Block (function 08): Notes

NOTE:
  • For control head having part number up to Index "K" 19 measuring value blocks with 4 measuring values are provided.
  • For control head having part number up to Index "M" 22 measuring value blocks with 4 measuring values are provided.
  • The readout which appears is either the actual or specified value valid at that moment, or the value for end stops of individual motors that was programmed and stored during the last basic setting.
  • The position of the flaps can be altered by operating the push-buttons of -E87-.
  • Before reading the measuring value block, check DTC memory. See DIAGNOSTIC TROUBLE CODE (DTC) MEMORY, CHECKING (FUNCTION 02)  . Repair any malfunctions which are displayed and then erase DTC memory. See DIAGNOSTIC TROUBLE CODE (DTC) MEMORY, ERASING (FUNCTION 05)  .
  • Changes to model year 2000. See CHANGES TO MODEL YEAR 2000 AND UP VEHICLES, OVERVIEW OF DISPLAY GROUP NUMBERS WHICH CAN BE SELECTED  .
  • If a malfunction is detected at an actuator motor (-V68-, -V71-, -V102 etc,) during basic setting, A/C control head -E87- with part number as of index "M" enters a replacement value for the impact which is not being reached. The malfunction "adaptation limit exceeded" is stored in DTC memory and the replacement value for this actuator motor will be displayed in value for this engine will not be displayed).
scientia non olet · About LEMON Manuals