Work step 3: Adapt throttle valve control module to Engine Control Module (ECM)
- Ignition switched on.
| Rapid data transfer HELP Select function XX |
When indicated on display
- Press buttons "04" for the function "Basic Setting" and press Q button to confirm input.
| System in Basic Setting Q Input display group number XXX |
When indicated on display
- Input "060" for "display group number 60" and press Q button to confirm input.
| System in Basic Setting 60 " 1 2 3 4 |
When indicated on display
- Check readiness code in display field 3 and 4:
| Display fields | ||||
| 1 | 2 | 3 | 4 | |
| Display group 60: Adaptation of throttle valve control module | ||||
| Display | xx % | xx % | x | --- |
| Indicated | Throttle valve angle (angle sensor 1) |
Throttle valve angle (angle sensor 2) |
Adaptation step counter | Adaptation condition |
| Work area | 0 - 100 % | 0 - 100 % | 0 - 8 | ADP running ADP OK ADP ERROR |
| Specified value: | 3 - 93 % | 97 - 3 % | 8 | ADP OK |
| During adaptation, adaptation step counter must reach the number 8. (Some numbers may be skipped). | If "ADP ERROR." is displayed: Check DTC memory. Refer to
Diagnostic Trouble Code (DTC) memory, checking and erasing . If specified value is not obtained: Refer to Possible reasons for the control module to abort the adaptation procedure: . |
|||
If specified value "ADP OK" is obtained:
- Press -C- button.