Final procedures
WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
After repair work, the following work steps must be performed in the mentioned sequence:
- - Check DTC memory. See MODE 3: CHECK DTC MEMORY .
- - If necessary, erase DTC memory. See MODE 4: RESET/ERASE DIAGNOSTIC DATA .
- - Generate readiness code. See READINESS CODE, GENERATING
.
- End diagnosis and switch ignition off.