Diagnostic Trouble Code (DTC) Memory, checking (function 02)
NOTE:
The DTCs indicated are only updated when initiating On Board Diagnostic (OBD)or with "Erase DTC Memory" function 05.
- Switch printer on by pressing PRINT button (indicator light in button comes on).
| Rapid data transfer HELP Select function XX |
Indicated on display:
- Press buttons -0- and -2- to select "Check DTC Memory" function 05.
| Rapid data transfer Q 02 - Check DTC Memory |
Indicated on display:
- Press -Q- button to confirm input.
| X DTC recognized → |
The number of stored Diagnostic Trouble Codes (DTCs) is shown on the display.
Stored DTCs are displayed in sequence and printed out one after another.
- Repair malfunctions printed out according to DTC Table. Refer to Diagnostic Trouble Code (DTC) table
| No DTC recognized → |
If "No DTC recognized" is shown on display
- Press → button to return VAG1551 scan tool to "Select function XX" mode.
| Rapid data transfer HELP Select function XX |
Indicated on display:
If anything else is indicated on display. Refer to VAG1551 Scan Tool (ST) operating instructions.
- Press buttons -0- and -6- to select "End Output" function 06. Refer to End Output (function 06) .
- Switch ignition off.
- Disconnect VAG1551 scan tool from DLC.