Output Diagnostic Test Mode (DTM) (function 03)
NOTE:
- The output Diagnostic Test Mode (DTM) can only be carried out on a stationary vehicle.
- Switch ignition on.
- Switch low beam on.
- If a malfunction is found during the output DTM, trace the cause and replace the malfunctioning part.
The following tests can be carried out by output DTM:
- Lowering headlights
- Raising headlights
Output DTM, initiating
- Press buttons -0- and -3- to select "Output Diagnostic Test Mode" function 03.
| Rapid data transfer Q 03 - Output Diagnostic Test Mode |
Indicated on display:
- Press -Q- button to confirm input (output DTM for headlight vertical headlight aim control system is started).
| Output Diagnostic Test Mode → Lower head lights |
Indicated on display:
Headlights will be lowered until sequence is switched ahead or the lowest position is reached.
- Press → button.
| Output Diagnostic Test Mode → Raise head lights |
Indicated on display:
Headlights will be raised until sequence is switched ahead or the highest position is reached.
- Press → button.
| Output Diagnostic Test Mode → END |
Indicated on display:
- Press → button.
The scan tool returns to the "Select function XX" mode.
| Rapid data transfer HELP Select function XX |
Indicated on display: