Diagnostic Trouble Code (DTC) memory (function 02), checking
| Rapid data transfer HELP Select function XX |
Indicated on display (function selection)
- Press buttons 0- and 2- to select "Check DTC Memory", function 02.
| Rapid data transfer Q 02 - Check DTC Memory |
Indicated on display
- Press -Q- button to confirm input.
| X DTC recognized |
Number of stored DTCs or "No DTC recognized" will be indicated on display.
| No DTC recognized → |
- Press → button.
The stored malfunctions are displayed and printed out in sequence.
- Using the DTC print-out, repair malfunction as instructed in DTC table: Refer to Diagnostic Trouble Code (DTC) table .
If "No DTC recognized!" is displayed, the program will return to "Select function XX" after the → button is pressed.
| Rapid data transfer HELP Select function XX |
Indicated on display (function selection)
- End Output (function 06). Refer to Ending Output (function 06) .
| Attention! → DTC Memory was not interrogated |
If the following is indicated on the display
- DTC memory has not been checked.
- Select Check DTC memory (function 02).
- Switch off ignition and disconnect diagnostic connector.
NOTE:
Work procedure upon recognizing a malfunction:
1. Repair malfunction as instructed in DTC table: Refer to Diagnostic Trouble Code (DTC) table .
2. Check DTC memory (function 02)
3. Erase DTC memory (function 05)
4. End Output (function 06)
5. Road test vehicle
6. Check DTC memory again