DTC Memory, checking

Procedure

NOTE:

If the engine does not start, crank engine using starter for at least 5 seconds, do not switch the ignition off afterward under any circumstances.

In diagnostic function "address word 33 - OBD" select "Diagnostic Mode 3: Check DTC memory.".
Select desired measured value according to "PID XX", e.g. "PID 05-Coolant temperature", via the following table.

NOTE:

The DTC tables are sorted by SAE code.
Measuring values of the Engine Control Module (ECM) J623 are displayed under "10 - Engine electronics" and measuring values of Transmission Control Module (TCM) J217 are displayed under "1A - Transmission electronics".
In addition, emission-relevant malfunctions are indicated in the instrument cluster via the lighting up of the Malfunction Indicator Lamp (MIL) K83.
Electronic throttle malfunctions are also indicated by the Electronic Power Control (EPC) Warning Lamp K132 in the instrument cluster.
In diagnostic Mode 2: Check operating conditions, it can be determined at which operating condition the Engine Control Module (ECM) J623 detected and stored a malfunction. → Diagnostic Mode 2: Obtain operating conditions .

Indication example	Explanation
P0444	SAE Diagnostic Trouble Code (DTC)
Evaporative Emission (EVAP) Canister Purge Regulator Valve	Malfunctioning wiring path or malfunctioning component
Circuit Open	Malfunction type as Text

SAE P0xxx-DTCs. → SAE P0xxx-DTCs .

SAE P1xxx-DTCs → SAE P1xxx-DTCs .

SAE P2xxx-DTCs. → SAE P2xxx-DTCs .

SAE P3xxx-DTCs. → SAE P3xxx-DTCs .

SAE U0xxx-DTCs, → SAE U0xxx-DTCs .

Final procedures

The following work steps must be performed in the described sequence after the malfunction(s) have been repaired: