Test-ID 61: Purge Flow Monitor
- Connect diagnostic tester. → Diagnostic tester, connecting .
- Start engine and let run at idle speed.
- In diagnostic function "address word 33 - OBD" select "Mode 6: Check test results of components that are not continuously monitored".
Select "Test-ID 61".
- Select desired "Component-ID".
- Check specified values at idle.
| Component-ID | Min. | Max. | Specified Value | ||
|---|---|---|---|---|---|
| 130 | Purge Flow Monitor | 0.0400 | 2.0001 | 0.9801 | |
- End diagnosis and switch ignition off.
If any of the specified values are not obtained:
- Check Evaporative Emission (EVAP) Canister Purge Regulator Valve N80 → Evaporative Emission (EVAP) Canister Purge Regulator Valve N80, checking .