Check DTC Memory (function 02)
NOTE:
The DTC information on the display is only updated when the On Board Diagnostic (OBD) is started or when function 05 "Erase DTC memory" is selected. The display is not updated constantly.
- Switch on printer with the PRINT button (indicator lamp in button lights up).
| Rapid data transfer HELP Select function XX |
Indicated on display
- Press buttons -0- and -2- to select "Check DTC Memory" function 02.
| Rapid data transfer Q 02 - Check DTC Memory |
Indicated on display
- Confirm entry with the -Q- button.
| X DTCs recognized! |
The number of stored DTCs appears in the display.
The stored DTCs are displayed and printed out one after the other.
- Check printout against Diagnostic Trouble Code (DTC) table and repair all malfunctions as necessary. Refer to Diagnostic Trouble Code (DTC) table for radio system .
| No DTC recognized! → |
If "No DTC recognized" is displayed the program will return to the start point after pressing the → button.
| Rapid data transfer HELP Select function XX |
Indicated on display
If something else is displayed:
Refer to Scan tool operating instructions
- End Output (function 06). Refer to End Output (function 06) .
- Switch off ignition and disconnect Data Link Connector (DLC).