Seat control element, basic setting: Notes

Basic setting must be performed if seat components are replaced.

Test requirements:

Voltage supply and fuses for the appropriate system OK.

Refer to Electrical Wiring Diagrams, Troubleshooting & Component Locations

Connect VAS 50511 Scan Tool (ST). Refer to VAS 5051 Scan Tool (ST), connecting .

Procedure

Move backrest as far forward as possible.
Check the existing value in Measuring Value Block 002. Refer to Read Measuring Value Block (function 08) .

Read measured value block 2 →
Not operated 32767 forward 34231

Indicated on display (example values):

Display zone 4 will show current value (in example 34231).

Note this value.
Move backrest back toward its normal seating position until the setting is 1082 units less than the original value (in example: 34231 minus 1082 = 33149).
Start basic setting.

Implementing function "04 - Basic setting"

Rapid data transfer HELP
Select function XX

Indicated on display:

Press buttons -0- and -4-.

Rapid data transfer Q
04 - Basic setting

Indicated on display:

Confirm entry with -Q- button.

Basic setting
Enter display group number XXX

Indicated on display:

Press buttons -0-, -0- and -1-.

Basic setting Q
Enter display group number 001

Indicated on display:

Confirm entry with -Q- button.

System in basic setting 1
Basic value learned

Indicated on display:

Basic setting complete.
Press the → button.

Rapid data transfer HELP
Select function XX

Indicated on display:

Check display zone 4 in measured value block 002. The display should show the numerical value for the central position (i.e. 32767).
Check the basic setting as follows:
Move the backrest as far back as possible.
Press the "memory" button and one of the personalized buttons (e.g. memory location 1).

With the driver's door open, press the selected personalized button again (e.g.: 1). The backrest will move back automatically to the rearmost position.

NOTE: A gap will always be left between the backrest and the rear seat to ensure that the rear passenger has enough leg room.

Deactivating remote control key memory function

In basic setting 004, all (simultaneously) memory functions for all 4 remote control key are erased.

Test requirements:

Voltage supply and fuses for the appropriate system OK.

Refer to Electrical Wiring Diagrams, Troubleshooting & Component Locations

Connect VAS 5051 Scan Tool (ST). Refer to VAS 5051 Scan Tool (ST), connecting .

Procedure

Basic setting
Enter display group number XXX

Indicated on display:

Press buttons -0-, -0- and -4-.

Basic setting Q
Enter display group number 004

Indicated on display:

Confirm entry with -Q- button.

System in basic setting 4
Basic value learned

Indicated on display:

Basic setting is complete.
Press the → button.

Rapid data transfer HELP
Select function XX

Indicated on display:

Check display value 4 in measured value block 001. The display must show 0000 when the "open" button is actuated on the remote control key.
Check the function as follows:
Lock the vehicle.
Unlock the vehicle using the remote control key.

The driver's seat adjustment must not change when the driver's door is opened.