Readiness code: Notes

The readiness code appears as an 8-digit display on measured value block 086, display zone 1. Each of the 8 digits is allocated to a particular emission-related system.

The function of each of these systems is checked by the self-diagnosis and the relevant position for the system in the 8-digit display is changed from "1" to "0" in a test sequence which must be fully completed.

The readiness code produced after successful completion of the test sequence is then "0 0 0 0 0 0 0 0" (measured value block 086, display zone 1).

If an individual test has been completed, but is "not OK", a DTC is entered in the Diagnostic Trouble Code (DTC) memory. Checking Diagnostic Trouble Code (DTC) memory. Go to DIAGNOSTIC TROUBLE CODE (DTC) MEMORY, CHECKING AND ERASING .

The readiness code is reset to "0 1 1 0 1 1 0 1" if:

Diagnostic Trouble Code (DTC) memory has been erased,
Voltage supply to the ECM has been interrupted (e.g. the connector disconnected, battery disconnected).
A new Engine Control Module has been installed

Generate readiness code. Go to READINESS CODE, GENERATING .

NOTE: When driving with varying loads the exhaust relevant tests are initiated by the control module and the readiness code produces itself. In this case the concluding control possibility is omitted, i.e. it is not obvious whether the vehicle was handed over to the customer without any DTCs.