Test-ID 163 ($A3): Mis-Fire Cylinder 2 Data
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Mode 6 Check test the results of components that are not continuously monitored".
Select "Test-ID 163 ($A3):".
-- Select the desired "Test-ID (TID)" or "Hex-ID".
-- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min./Max. Values | Additional Information | |
|---|---|---|---|---|---|
| 11 ($0B) | P0302 | Misfire cylinder 2, Average value over 10 Driving Cycles. | 0 - 65535 (counts) | Refer to DTC P0302 in the SAE P0XXX DIAGNOSTIC TROUBLE CODES . | |
| 12 ($0C) | P0302 | Misfire cylinder 2, in this Driving Cycle. For additional information, refer to the Bosch Motronic MED 9 OBD System Strategy. Page 11. | 0 - 65535 (counts) | Refer to DTC P0302 in the SAE P0XXX DIAGNOSTIC TROUBLE CODES . | |
-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC's or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition off.
-- End of diagnosis.