Diagnostic Mode 01 - Read Current System Data
Diagnostic Mode 01 makes it possible to access current emissions-related measured values and diagnostic data. The original measured values (no replacement values), input and output data and system status information are displayed using Diagnostic Mode 1.
Test requirement
- Coolant temperature at least 80° C.
Procedure
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Diagnostic Mode 1: Obtain data.".
-- From the following table, select the desired the "PID" that is to be monitored, e.g. "PID 05-Coolant temperature".
NOTE:
More than one "PID" may be selected and monitored.
The current values of the component or system that is being monitored will be displayed on the scan tool screen.
| PID | Component or System |
|---|---|
| 01: | Monitoring status sinceerasing DTC memory |
| 03: | Condition of fuel system |
| 04: | Calculated load condition value |
| 05: | Coolant temperature |
| 06: | Short term gasoline-air ratio bank 1 |
| 07: | Gasoline-air ratio bank 1 |
| 12: | Engine rotations per minute (RPM) |
| 13: | Vehicle speed |
| 14: | Ignition timing adjustment at 1. cyl. in direction |
| 15: | Intake air temperature (IAT) |
| 16: | Air flow quantity at Mass Air Flow (MAF) sensor |
| 17: | Throttle valve position (absolute) |
| 19: | Existing oxygen B1 to B2-S2 to (exist./nonexist.) |
| 21: | Bank 1 - sensor 2 |
| 28: | OBD request is designed for diagnostic of this vehicle |
| 31: | Time after engine on |
| 33: | Driven distance after MIL on |
| 35: | Fuel Rail Pressure |
| 46: | Commanded Evaporative Purge |
| 48: | Number of warm ups since diagnostic trouble codes |
| 49: | Distance since diagnostic trouble codes cleared |
| 51: | Barometric Pressure |
| 52: | Bank 1 - sensor 1 |
| 56: | Bank 2- sensor 1 |
| 60: | Catalyst Temperature Bank 1, Sensor 1 |
| 65: | Monitor status this driving cycle |
| 66: | Control module voltage |
| 67: | Absolute Load Value |
| 68: | Commanded Equivalence Ratio |
| 69: | Relative Throttle Position |
| 70: | Ambient air temperature |
| 71: | Absolute Throttle Position B |
| 73: | Accelerator Pedal Position D |
| 74: | Accelerator Pedal Position E |
| 76: | Commanded Throttle Actuator Control |
-- Switch the ignition off.
-- End of diagnosis.