Control module and output signals

WARNING: This page is about a different variant/trim than selected.

DTC	Error Message	Diagnostic Procedure	Malfunction Criteria and Threshold Value	Secondary Parameters with Enable Conditions	Monitoring Time Length	Frequency of checks, MIL Illum
U0001	High Speed CAN Communication Bus	Check the CAN-Bus terminal resistance. Refer to → Terminal Resistance for Can-Bus, Checking .	CAN message, No feedback CAN level, Incorrect	Battery voltage, >9 V Delay after ignition on, 0.5 Sec. Ignition status, On	0.3 Seconds 0.06 Seconds	Continuous Immed.
U0100	Lost Communication With ECM/PCM A	Check the CAN-Bus terminal resistance. Refer to → Terminal Resistance for Can-Bus, Checking .	No message received from DME, Timeout	CAN Bus, No error and ready to transmit Delay after ignition on, 0.53 Sec. Battery voltage, >9 V	0.5 Seconds	Continuous 2 DCY
U0101	Lost Communication with TCM	CAN-Bus terminal resistance, Transmission Control Module (TCM) J217 to Engine Control Module (ECM) J623. Refer to → Terminal Resistance for Can-Bus, Checking .	CAN message, No message		0.51 Seconds	Continuous 2 DCY
U0302	Software Incompatibility with Transmission Control Module	Replace the Transmission Control Module (TCM) J217. Refer to → Transmission Control Module (TCM) J217 , Replacing .	AT vehicle ECM coded as MT vehicle		5 sec.	Continuous 2 DCY
U0401	Invalid Data Received From ECM/PCM	Replace the Engine Control Module (ECM) J623. Refer to → Engine Control Module (ECM) J623 , Removing and Installing .	Invalid data.	CAN Bus, No error and ready to transmit Delay after ignition on, 0.53 Sec. Battery voltage, >9 V	0.5 Seconds	Continuous 2 DCY
U0402	Invalid Data Received from Transmission Control Module	CAN-Bus terminal resistance, Transmission Control Module (TCM) J217 to Engine Control Module (ECM) J623. Refer to → Terminal Resistance for Can-Bus, Checking .	AT vehicle ECM coded as MT vehicle CAN message Implausible message		5 Sec.	Continuous 2 DCY