ATF, filling for ATF flushing process

CAUTION:

The Multitronic 01J or 0AN transmission requires a different ATF than shift automatics. Only ATF for CVT transmission which can be obtained as replacement part must be used .
Do not allow engine to run without filling ATF and do not tow the vehicle.

Fig 1: Identifying Illustration On Reservoir For ATF Filler System F/CVT Transmission VAS5162

Courtesy of VOLKSWAGEN UNITED STATES, INC.

NOTE:

The illustration on the reservoir for ATF filler system F/CVT gearbox VAS 5162 in upper left graphic refers to the use of special ATF for CVT transmissions.
The illustration also shows pictures of the steps required to fill the transmission. These steps will be explained in the following.

Fig 2: Securing Filled Reservoir Of ATF Filler System F/CVT Gearbox VAS 5162 As High As Possible On Vehicle

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Secure filled reservoir of ATF filler system F/CVT gearbox VAS 5162 as high as possible on the vehicle.

The shut-off valve on the ATF filler system F/CVT gearbox VAS 5162 must be closed.

CAUTION:

Engine must not be started if only a small amount or no ATF is in the transmission after repair work or after significant ATF loss.
In this case, a preliminary filling with 4.5 to 5 liters ATF must be performed.

Fig 3: Identifying ATF Check Plug

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove ATF check plug - B -.
Thread connection on shut-off valve of ATF filler system F/CVT gearbox VAS 5162 into opening of ATF check plug - B -.

Fig 4: Securing Filled Reservoir Of ATF Filler System F/CVT Gearbox VAS 5162 As High As Possible On Vehicle

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Rotate shut-off valve in direction of filler hose - lower arrow -. ATF flows into transmission.
Fill transmission with 5 Liter ATF.
Selector lever in "P" , start engine and let it run at idle.

CAUTION: Let engine run at high speed at "2500 - -3000 RPM" for approx. 4 to 5 seconds immediately after starting.

Running the engine at high speeds is necessary so that the ATF pump is bled after a transmission repair.

If running at high speeds is not performed, the transmission can be damaged.

Start engine
By pressing the gas pedal, run engine at high speed at "2500 - -3000 RPM" for approx. 5 seconds.
Press brake pedal and hold.
Shift through all selector lever positions "P, R, N, D, S" and let each position remain shifted at idle for approx. 2 seconds.

Fig 5: Identifying ATF Check Plug

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Thread connection on shut-off valve of ATF filler system F/CVT gearbox VAS 5162 from ATF check plug opening - B -.
Allow excess ATF to drain off.
Install ATF check plug - B -.