Diagnostic Mode 01 - Read Current System Data
Diagnostic Mode 01 makes it possible to access current emissions-related measured values and diagnostic data. The original measured values (no replacement values), input and output data and system status information are displayed using Diagnostic Mode 1.
Test Requirement
- Coolant temperature at least 80° C.
Procedure
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Diagnostic Mode 1: Obtain data.".
-- From the following table, select the desired "PID" that is to be monitored, e.g. "PID $05 Coolant temperature".
The current values of the component or system that is being monitored will be displayed on the scan tool screen.
| PID | Component or System |
|---|---|
| $00: | Supported Definition PIDs $01 Thru $20 |
| $01: | Monitoring Status Since Erasing DTC Memory |
| $03: | Condition Of Fuel System |
| $04: | Calculated Load Value |
| $05: | Coolant Temperature |
| $06: | Short Term Air Fuel Ratio |
| $07: | Long Term Air Fuel Ratio |
| $08: | Short Term Air Fuel Ratio |
| $09: | Long Term Air Fuel Ratio |
| $0B: | Manifold Pressure |
| $0C: | Engine Speed |
| $0D: | Vehicle Speed |
| $0E: | Ignition Timing Advance For #1 Cylinder |
| $0F: | Intake Air Temperature |
| $10: | Air Mass |
| $11: | Throttle Valve Position 1 Absolute |
| $12: | Secondary Air Injection |
| $13: | Location Of Oxygen Sensor |
| $15: | Oxygen Sensor Bank 1 Sensor 2 |
| $19: | Oxygen Sensor Bank 2 Sensor 2 |
| $1C: | OBD Requirements |
| $1F: | After Starting Engine |
| $20: | Supported Definition PIDs $21 Thru $40 |
| $21: | Distance Driven With MIL On |
| $23: | Fuel Rail Pressure |
| $2E: | Commanded Evaporative Purge |
| $30: | Warm Up Counts After MIL Erased |
| $31: | Distance Driven After MIL On |
| $33: | Ambient Pressure |
| $34: | Lambda Value Bank 1 - Sensor 1 |
| $38: | Lambda Value Bank 2 - Sensor 1 |
| $3C: | Catalyst Temperature Bank 1 - Sensor 1 |
| $3D: | Catalyst Temperature Bank 2 - Sensor 1 |
| $40: | Supported Definition PIDs $41 Thru $60 |
| $41: | Monitor Status Current Drive Cycle |
| $42: | ECU System Voltage |
| $43: | Absolute Load Value |
| $44: | Specified Value Of Oxygen Sensor Signal |
| $45: | Relative Throttle Position |
| $46: | Ambient Temperature |
| $47: | Throttle Valve Position 2 Absolute |
| $49: | Driving Pedal Position 1 Absolute |
| $4A: | Driving Pedal Position 2 Absolute |
| $4C: | Set Throttle Position |
| $56: | Offset Lambda Control Behind Catalyst, Bank 1 |
| $58: | Offset Lambda Control Behind Catalyst, Bank 2 |
-- Switch the ignition off.