Monitor-ID A5 : Mis-Fire Cylinder 4 Data
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "Monitor-ID A5".
-- Select the desired "Test-ID (TID)" or "Hex-ID".
-- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min./Max. Values | Additional Information | |
|---|---|---|---|---|---|
| 11 ($0B) | P0304 | Misfire cylinder 4, Average value over 10 Driving Cycles. | 0 - 65535 (counts) | Refer to DTC P0304 in the DTC summary table. DTC TABLES . | |
| 12 ($0C) | P0304 | Misfire cylinder 4, in this Driving Cycle. | 0 - 65535 (counts) | Refer to DTC P0304 in the DTC summary table. DTC TABLES . | |
-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition off.
-- If any of the components or systems fail to meet the specified values, refer to Diagnostic Mode 03: Interrogating Fault Memory to check for stored DTCs or the corresponding diagnostic repair procedure.
-- Switch the ignition off.