LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 2008 >> A5 Automatic >> Repair and Diagnosis (Single Page) >> Engine Performance >> Engine Control Systems >> GENERIC SCAN TOOL [CALA] (1 Of 2) (COUPE) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 09 >> Diagnostic Mode 07 - Read Faults Detected During The Current Or Last Driving Cycle >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Mode 07 - Read Faults Detected During The Current Or Last Driving Cycle: Procedure

-- Connect The Scan Tool.

-- Start The Engine And Run At Idle.

NOTE:

If The Engine Does Not Start, Crank The Engine Using Starter For At Least 5 Seconds. Do not Switch The Ignition Off Afterward.

-- Select "Mode 7: Check \ Test Results Of Components That Are Continuously Monitored".

The Number Of Pending DTCs Or 0 Malfunctions Detected Will Be Displayed On The Scan Tool Screen.

-- Refer To The DTC Tables Below For The Diagnostic Repair Procedures.

-- Switch The Ignition Off.

scientia non olet · About LEMON Manuals