Ignition Assembly Overview
Courtesy of AUDI OF AMERICA, LLC
- Ignition Coil Connector
- Bolt
- 3-Pin Connector
- Camshaft Position Sensor
- Camshaft position sensor -G40- cylinder bank 1
- Camshaft position sensor 3 -G300- cylinder bank 1
- Camshaft position sensor 2 -G163- cylinder bank 2
- Camshaft position sensor 4 -G301- cylinder bank 2
- O-ring
- Replace if damaged
- Coat with clean engine oil.
- Bolt
- 20 Nm
- Tightening specifications affect function of Knock Sensor (KS)
- Knock Sensors
- Contact surfaces between knock sensor and cylinder block must be free of corrosion, dirt and grease
- Knock sensor 1 -G61- cylinder bank 1
- Knock sensor 2 -G66- cylinder bank 1
- Removing and installing, refer to KNOCK SENSORS
- Spark Plug
- Ignition Coil
- Ignition Coil 1 with power output stage -N70-
- Ignition Coil 2 with power output stage -N127-
- Ignition Coil 3 with power output stage -N291-
- Ignition Coil 4 with power output stage -N292-
- Ignition Coil 5 with power output stage -N323-
- Ignition Coil 6 with power output stage -N324-
- Removing and installing, refer to IGNITION COILS
- To remove, use the ignition coil puller:T40039