Steering Column, Removing And Installing: Notes
Special Tools And Workshop Equipment Required
- Torque Wrench 1331 5-50 Nm :VAG1331
WARNING:
Note The Following Before Removing The Steering Column:
Create a sketch showing the:
- routing of the electrical wiring harnesses,
- securing the electrical wiring harnesses,
- cable tie locations.
This especially applies to the wiring harness to the Electronic Steering Column Lock Control Module -J764-.
Note The Following Before Installing The Steering Column:
- Route the wiring harnesses exactly the way they were before removal.
- Secure the wiring harnesses exactly the way they were before removal.
- Install all the cable ties that were loosened or cut in the same locations when installing the steering column.
- Make sure the wiring harness to the Electronic Steering Column Lock Control Module -J764- is not pinched and does not come into contact with sharp edges when adjusting the steering column.