Selector Mechanism Assembly Overview
NOTE:
Lubricate mounting points and contact surfaces with polycarbamide grease.
- Mounting Bracket
- For selector lever cable
- Bolt
- Replace
- 20 Nm plus an additional 90°
- Qty. 2
- Lock Washer
- Replace
- Bolt
- 13 Nm
- Securing Plate
- Replace
- Selector Lever Cable
- Do not bend or kink
- If selector lever cable boots are damaged, replace
- Adjusting, refer to SELECTOR LEVER CABLE, ADJUSTING
- Removing and installing, refer to SELECTOR LEVER CABLE
- Do not lubricate cable eye
- Nut
- 8 Nm
- Shift mechanism to body
- Qty. 4
- Stop Buffer for Selector Lever
- Clipped into selector mechanism
- Selector Mechanism Function Unit
- With integrated selector mechanism circuit board (selector lever -E313-)CAUTION:
Risk of destroying electronic selector mechanism components with static discharge.
- Do not touch circuit board with fingers.
- With integrated tiptronic switch -F189- and shift lock solenoid -N110-.
- Check tiptronic switch -F189- or shift lock solenoid -N110- in guided fault finding .
- If tiptronic switch -F189- or shift lock solenoid -N110- are faulty, replace selector mechanism function unit..
- Perform selector mechanism emergency release. Refer to SELECTOR MECHANISM EMERGENCY RELEASE, PERFORMING
- Removing and installing. Refer to TIPTRONIC SWITCH .
- With integrated selector mechanism circuit board (selector lever -E313-)
- Locking Spring
- Bolt
- 3.5 Nm
- Pivot Pin
- Bolt
- 3.5 Nm
- Qty. 4
- Locking Plate
- Selector Mechanism Shift Unit
- With bonded-on gasket
- Nut
- Replace
- 9 Nm
- Qty. 4
- Self-locking
- Bracket
- Lock Washer
- Qty. 2
- Securing Plate
- Replace