LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 2009 >> S5 Automatic >> Repair and Diagnosis (Single Page) >> Engine Performance >> Engine Control Systems >> Generic Scan Tool (CAUA) (1 Of 2) (Coupe) >> Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 0A >> Diagnostic Mode 07 - Read Faults Detected During The Current Or Last Driving Cycle >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Mode 07 - Read Faults Detected During The Current Or Last Driving Cycle: Procedure

-- Connect the scan tool.

-- Start the engine and run at idle.

NOTE:

If the engine does not start, crank the engine using starter for at least 5 seconds. Do not switch the ignition off afterward.

-- Select "Mode 7: Check test results of components that are continuously monitored".

The number of pending DTCs or "0 malfunctions detected" will be displayed on the scan tool screen.

-- Refer to the DTC tables below for the diagnostic repair procedures:

-- Switch the ignition off.

scientia non olet · About LEMON Manuals