Checking Electrical Circuit
If the manufacturers test box is being used, perform the following step.
-- Install the test box.
If the manufacturers test box is not being used, perform the following step.
-- Remove the Engine Control Module (ECM) -J623-. refer to the appropriate service information.
-- Using a multimeter, check the Mass Air Flow (MAF) Sensor -G70- electrical harness connector terminals to the Engine Control Module (ECM) -J623- electrical harness connector T94 terminals for an open circuit.
| Mass Air Flow (MAF) Sensor -G70- electrical harness connector terminals | Engine Control Module (ECM) -J623- electrical connector T94 terminals or test box socket |
|---|---|
| 1 | 23 |
| 2 | 65 |
Specified value: 1.5 Ω max.
If the specification is not obtained:
-- Check the wiring for a short circuit to each other, Battery (+), and Ground (GND).
-- Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-- If necessary, repair the faulty wiring connection.
If no malfunction is detected in the wiring and if the voltage supply was OK:
-- Replace Mass Air Flow (MAF) Sensor -G70-. Refer to appropriate service information.
If no malfunction is detected in the wiring and if the voltage supply was not OK:
-- Replace the Engine Control Module (ECM) -J623-. Refer to appropriate service information.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
- Check the DTC memory. Refer to DIAGNOSTIC MODE 03 - READ DTC MEMORY .
- If necessary, erase the DTC memory. Refer to DIAGNOSTIC MODE 04 - ERASE DTC MEMORY .
- If the DTC memory was erased, generate readiness code. Refer to READINESS CODE .