Function Test
NOTE:
If the accelerator pedal is depressed during the test, the test will be aborted.
-- Connect the scan tool.
-- Start the engine and run at idle for at least 15 minutes.
-- Select "Mode 8: Tank Leak Test".
-- Select "Test-ID 01: Tank Leak Test".
-- Check the specified value of the tank leak test at idle.
-- The following will be displayed on the scan tool screen:
| TANK LEAK TEST | SPECIFIED VALUE | |||||
|---|---|---|---|---|---|---|
|
Test OK | |||||
-- Ignition switched OFF.
If the specified result is obtained:
System OK.
If the specified result is not obtained:
-- Repeat the tank leak test, switch the ignition OFF and start the engine again and let run for 15 minutes at idle.
-- Ignition switched OFF.
If the specified result is again not obtained:
-- A leak may be present. Refer to EVAP SYSTEM, CHECKING FOR LEAKS .