Monitor-ID $3D: EVAP Valve Function Check
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "Monitor-ID 61 ".
-- Select the desired "Test ID " or "Hex-ID".
-- Check specified values at idle.
| Test ID | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| $80 | P0441 | EVAP Valve Function Check from % DTEV: Active test Air balance at idle OK, (Normal operation and short test 70). | 8% | 100% | Refer to DTC P0441 in the DTC summary table. Engine Control Module -- => P0441 |
| $82 | P0441 | EVAP Valve Function Check from %DTEV: Active test, Oxygen sensor regulator deviating in rich direction (can only test OK), | 4% | 100% | Refer to DTC P0441 in the DTC summary table. Engine Control Module -- => P0441 . |
| $83 | P0441 | EVAP Valve Function Check from %DTEV: Active test, Test mixture of deviation (quick test) (can only test OK), | 0.2 V PWM Controlled | 1.99 V PWM Controlled | Refer to DTC P0441 in the DTC summary table. Engine Control Module -- => P0441 |
| $8A | P0441 | Evaporative Emission System. Incorrect Purge Flow. | 4 kPa | + / - 327.67 kPa | Refer to DTC P0441 in the DTC summary table. Engine Control Module -- => P0441 |
-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition OFF.